It is well known that CCNA 640-822 - 640-822 exam test is the hot exam of Cisco certification. pass4line offer you all the Q&A of the 640-822 real test . It is the examination of the perfect combination and it will help you pass 640-822 exam at the first time!

The CCNA 640-822 Questions and Answers as well as our other CCNA 640-822 exam training tools are not only priced to be easy on your budget - but each one is also backed with our guarantee. pass4line guarantees that after using our Cisco certification training tools, you will be prepared to take and pass your CCNA 640-822 exam.

　
　
Exam : Cisco 640-822
Title : Interconnecting Cisco Networking Devices Part 1


1. Refer to the exhibit. A network technician is attempting to use HyperTerminal to configure a new router using the settings shown. What is the reason the technician is unable to connect to the router?
A. The bits per second should be set to 9600.
B. The data bits should be set to 6.
C. Parity should be set to mark.
D. The stop bits should be set to 2.
E. Flow control should be set to hardware.
Answer: A

2. Refer to the exhibit. Workstation A must be able to telnet to switch SW-A through router RTA for management purposes. What must be configured for this connection to be successful?
A. VLAN 1 on RTA
B. default gateway on SW-A
C. IP routing on SW-A
D. cross-over cable connecting SW-A and RTA
Answer: B

3. Refer to the exhibit. A network technician has added host A to the network. Host A cannot communicate on the network. A ping that is issued on the host to address 127.0.0.1 fails. What is the problem?
A. The router is not forwarding the ping packets to network 127.0.0.0.
B. The remote host at 127.0.0.1 is unreachable.
C. The default gateway is incorrect.
D. The IP address of host A is incorrect.
E. The TCP/IP protocols are not loaded.
Answer: E

4. Which line from the output of the show ip interface command indicates that there is a Layer 1 problem?
A. Serial0/1 is up, line protocol is up
B. Serial0/1 is up, line protocol is down
C. Serial0/1 is down, line protocol is down
D. Serial0/1 is administratively down, line protocol is down
Answer: C

5. Refer to the exhibit. What could be possible causes for the "Serial0/0 is down" interface status? (Choose two.)
A. A Layer 1 problem exists.
B. The bandwidth is set too low.
C. A protocol mismatch exists.
D. An incorrect cable is being used.
E. There is an incorrect IP address on the Serial 0/0 interface.
Answer: AD

Our on-site online training experts create all of the Cisco 640-822 exam products available through pass4line. Our main goal is to get your certified with a firm understanding of the core material. Whereas other online distributors only concern themselves with helping you obtain the paper, we strive to educate the certification candidate and better prepare them for their IT career.

Why choose pass4line 640-822 braindumps

Quality and Value for the 640-822 Exam
100% Guarantee to Pass Your 640-822 Exam
Downloadable, Interactive 640-822 Testing engines
Verified Answers Researched by Industry Experts
Drag and Drop questions as experienced in the Actual Exams
Practice Test Questions accompanied by exhibits
Our Practice Test Questions are backed by our 100% MONEY BACK GUARANTEE.